Question:

How do I install a strip floor with a herringbone pattern?

Answer:

Dear Dennis

This type of floor is generally glued down these days. I suggest a very level, dry subfloor. It should be flat to within 3/16" in 10 feet, or 1/8" in 6 feet. Correct the subfloor if is not. A concrete floor needs to be moisture tested. Use only Dri-Tac 6200 adhesive (www.dritac.com). It's the best. Oh, and make sure they are identically sized pieces, from a reputable mill (stored properly also) or they will never fit well.

Find the center point of the room, exactly. Lay two chalk lines at right angle to this center to both walls. Test this with the 3'-4'-5' triangle (remember the Pythagorean theory). You now have a large cross in the room, with its intersection exactly in the center. Now snap another exactly 45 degree line through this center. Next snap another chalk line exactly half the width of the herringbone board below this diagonal line. Dry lay the boards (without adhesive) to get a good idea of how it's done. The first board is laid right on the line below the center diagonal and it's end (and middle) just touching the center spot. The second one is laid and right angles and on top of this, and so on for three row up. Now lay the boards to the left along the line. You ninth board should be along this same starting line. Go up the diagonal line until you have dry laid about 20 boards.

The make a rough pencil line around these boards, remove them. And now spread the glue. You should be able to see the chalk line through the glue, once it has tacked off (follow Dri-Tac's excellent instructions). Relay the pieces in the same order. Allow the glue to set up on these 20 pieces for about an hour, then roll, then and wait anther hour until they cannot be moved out of place by hand. Now you can apply more adhesive in any direction you wish and continue, but try to fill most of the one quadrant of the room at a time. And be sure you don't spread too much glue so that it dries and won't accept the wood.

You may also find these articles helpful:

1. Parquet Flooring

2. Stopping Those Annoying Squeaks In Your Wood Floors

3. How To Chemically Strip Wood Floors without dust!

4. Prefinished Hardwood Floors: How To Choose!

5. How To Take Care Of Your Health And Safety when Installing, Finishing, Repairing or Cleaning your wood floors


Find Local Businesses: